your current location:首页 > news>V10 fission reactor [Mek] General Machine (Mekanism) Minecraft Game

V10 fission reactor [Mek] General Machine (Mekanism) Minecraft Game

2024-12-09 18:27:54|Myriagame |source:minecraft skins

V10 nuclear fissure reactor

In Mekanism V10, the machine has changed a lot, and an essential machine is the fission reactor.However, this machine is extremely dangerous, and it will explode without paying attention.So let me write a tutorial to avoid the nuclear explosion tragedy.

structure

The fission reactor structure must be a rectangular (along X, Y, and Z) with a minimum size of 3X4X3, and the maximum is 18x18x18.

The edge of the shell must be made of a fission reactor shell. The surface of the shell can be the logic adapter of the fission reactor shell, reinforced glass, fission reactor port or fission reactor.The interior of the reactor can be air or fission control stick:

The control rod consists of 1x1 wide columns composed of 1 to 15 cracking fuel components and a single control component at the top

The control stick must not be in contact with each other.The maximum control stick density can be achieved by the mode of placing in the checkerboard, that is, the fuel rod similar to the BR.Each fission fuel component can provide a maximum burning rate of 1MB.

temperature

Core temperature: green (<600K): best,

Yellow (> 600K <1000K): hotter,

Orange (> 1000K <1200K): Dedicated by experts,

Red (> 1200K): The reactor is being damaged by structural destruction, and it will soon be melted and eventually nuclear.Therefore, the temperature of the reactor must not exceed 1200K.

The larger the reactor, the lower the calories at the same combustion rate.

damage

This indicates that the actual structure of the reactor is damaged.When a reactor reaches a critical temperature, it will begin to be damaged, and this value will rise.The reactor that runs normally and stops runs will slowly reduce its own damage value without the need for players to intervene.

Cooling and capacity

There are two cooling methods for fission reactors, water cooling and sodium cold.No matter what kind of cooling method, the fission reactor cannot be main production capacity, and the coolant can only be heated.The final capacity depends on turbine.

Water -cooled

As the name suggests, use water to cool down.The water steam is generated, so it can be directly connected to the turbine, and the turbine back water can be directly connected to the reactor.

The limit of water cooling is poor cooling effect.The temperature of water and cooling piles will be higher, which limits its combustion rate.If it is too high, even if the water is sufficient, it cannot suppress the temperature, and the last is a nuclear explosion.

Advantage: convenient and fast, low cost of unit cost, suitable for preliminary use

Disadvantages: The upper limit of the rate is limited

Sodium

When the water -cooled reactor does not meet your requirements due to the rate limit, sodium is a more effective coolant, which is lower than the temperature heap at the same combustion rate.The sodium cold reactor requires a thermal boiler as an intermediate thermal exchanger to cool down the overheated sodium in the reactor and heat the water into steam.The thermal boiler has been updated in Mekanism V10 so that it can use thermal coolant as the heat source.

Advantages: Cooling is excellent, and can even support the burning rate of 1400MB in the maximum reactor.

Disadvantages: Require a thermal boiler, high cost, and a large amount of sodium steam needs to accumulate for a long time.

Fuel production

The fission reactor consumes fission fuel, while fission fuel requires a large amount of uranium ore, sulfur powder, water, and fluorite (distinguish the original fluorite !!!).

1: Put sulfur powder into a chemical oxide machine and produce sulfur dioxide

2: Mix sulfur dioxide and oxygen in the chemical irrigation machine to produce sulfur dioxide

3: Mix sulfur dioxide and water vapor to form sulfuric acid

4: Mix fluorite and sulfuric acid in the chemical solubility room to form hydrofluoric acid

5: Put the processed uranium ingots (processing the same iron ore, etc.) into a rich collection position to make uranium yellow cake

6: Put the uranium cake into a chemical oxide machine to form uranium oxide

7: Mix hydrofluoric acid and uranium oxide in chemical irrigation machines to form hexal fluoride

8: Putting hexaronal uranium into a dexicant of the isotope to form fission fuel

At this point, you have been able to build a fission reactor that can be used.

breaker

The stability of the fission reactor is poor, even if some small faults in the crew will cause serious problems.Therefore, it is very important to automatically shut down when the temperature is too high.

The picture shows a simple and effective circuit breaker based on the edge detector.

The bottom fission reactor logic adapter is set to send a redstone signal at high temperature.The top one is set "activation".This will activate the reactor when receiving the redstone signal and turn off the reactor when the signal is closed.

The piston is an ordinary piston with sand or gravel on the top.Observer is facing the gravel and sends the signal to the reactor adapter.The only problem is that when the circuit breaker is established, it is properly placed an observer (and check it three times to set the adapter to "activation"!).Whenever the bottom adapter is sent to the redstone signal, it will promote the piston and gravel, so that the observer sends a tick pulse to the reactor, activates itMake it underworld.The redstone torch is not part of the circuit breaker itself (see below).

Disclaimer: The use of circuit breakers alone cannot work in all circumstances.If the reactor is overheated, the reactor is large, the combustion rate is high and the critical coolant is shortage. Before the circuit breaker, the temperature will reach 1400K.If a new coolant is not injected quickly, the reactor will not be cooled enough enough, and it will continue to be destroyed by structural damage until something that cannot be imagined will happen.This is the purpose of the redstone fire handlebar and redstone on the right side.This tube is connected to a container stored as an emergency cooling agent.As long as the high -temperature signal is turned on, the pipeline will inject fresh coolant from the emergency box to the reactor, so that the temperature of the reactor immediately drops to the safe level, and the circuit breaker will close the reactor.

Sometimes the gravel may be destroyed after falling. At this time, you can consider the viscous piston stone instead of the original breaking the circuita. It was originally just to save a mucus ball.

Nuclear waste treatment

Nuclear waste will be generated after the cracking fuel is burned.So how to deal with nuclear waste?Throw it away?

Of course not.Nuclear waste can make new items by processing, and new items are widely used, and it is also a necessity for MEK development.

钚 钚 钚 钚 钚

Alas, it is a material obtained by nuclear waste through isotope.Its effect is mainly to make a ball. The ball can make a supercritical migrant. When the fuel is insufficient, it can also be re -made into fission fuel to achieve circulating utilization

钋 钋 钋 钋 钋

太 is the material obtained by nuclear waste through solar neutron reactor.Its effect is extremely wide, including production as a ball, so as to make supercritical phase migrants, MEKA equipment and its upgrade components, fusion reactors, etc.界 界 can also pass the supercritical phase migrant and make anti -substances.

Anti -material production and application

The anti -material is the ultimate material obtained from the supercritical of the supercritical.Anti -substances can be used as a chemical crystallizer to make anti -material balls. Anti -material balls can make anti -proton nuclear compoilers, gravity regulating modules, transmitting modules and QIO arrays to finally store component uranium oxide.In addition, anti -substances can also be used as an anti -quality subcounter to make precious materials, such as coal becomes diamonds, and diamonds become emerald.

radiation

In any case, security is the most important.But even if it is better, radiation is still easy to leak.The main reason is that the wastewater sink is full, and containers and pipes with radioactive items are damaged and nuclear.Therefore, the nuclear waste should not be stored. It can be used as soon as possible to make it as soon as possible to avoid leakage.

If the radiation has been leaked, what you can do is wear a full set of radiation -proof uniforms, or install a Meka set with radiation -proof module, and then wait for the radiation to dissipate naturally (no radiation machine, bad review) to dissipate for several hours to tens of hours.Wait, depend on the degree of leakage.

Precautions

1: Never let the hard work afraid of hovering near the nuclear waste treatment device, otherwise it will be cool to death

2: You must not cache the energy of the turbine, otherwise the steam consumption will be reduced, the return to the water will decrease, and the temperature will increase

3: The only combustion rate is determined by the reactor power generation, the number of fan blades and boiling efficiency of the turbine is not related to the water cooling and sodium cold.

4: Be sure to confirm the steam acceptance efficiency of the turbine and water return efficiency, and the heating efficiency of boiler can keep up with the reactor

5: The radioactive waste barrel is mainly when the cache nuclear waste device is cached. At the same time, because it deletes the nature of 1MB of the contents per minute, the nuclear waste generated after the pressure reaction room can be used after the ball and the ball can be passed.

6: Make sure that the overall reactor is located in a permanent loading block. It can be placed near the world's birth point or installed with an anchor upgrade machine to ensure that the block is loaded

7: Stay away from the village, farm, etc. to avoid nuclear leakage village tragedies

8: Chemical storage tanks cannot store nuclear waste, and quantum teleportation devices cannot transport nuclear waste. The only transportation method is to compress the catheter. The storage method is the radioactive waste barrel

The first time the newcomer will be sent, and the follow -up will continue to be improved. I hope everyone will graduate early, and the early nuclear explosion will give me the reasons for the failure of the fault.