1.10.2DE2 aggregation device-pure AE2 automation (no-labeling item) -Solo-item separation use [de] dragon evolution/drag

2024-12-09 18:28:14|Myriagame |source：minecraft skins

This tutorial is set by the author's setting without permission.

Note: 1.10.2, pure AE2, non -marked items

(Although not many people play 1.10.2, but this is also considered an attempt, challenge)

1.12.2 The aggregation device of the de is that the surrounding injection device can only be installed by the surrounding injection device, which is completely consistent with the mysterious 4 magic magic. It is even simpler than the Demon.

Through Thermal series and EIO, items can be separated by one by one.But only AE2 is used here.

Add the synthetic table and just put in the template.

Of course, it is feasible for all renamed anti -stacks, but it is not discussed.

1. Single item pulls away

As shown in the figure, the two input bus in the middle each put a acceleration card, and 8 items are drawn each time.Eight input bus on each side does not release acceleration cards, and 1 item is drawn at each time.Realize at most 16 items to 16 bases.Can expand.(Each 8 input bus cannot be changed to 9)

(16 foundations are because they did not look at the full synthetic table when I did it, and 16 were put in 16)

Second, priority

The storage bus under the middle box is low priority, and the accumulated core storage bus priority is high:

3. Match control of single -portal items

The sender is> = 1 to send a signal, that is, the items in the aggregation core are disconnected from the block interface.

ME interface enable blocking mode of the main network

Fourth, finished product recycling

The input bus only draws the finished product due to its characteristics.Just send the finished product home directly

Synthetic simulation

1. A part of the item is distributed to the square interface. The first group was put into the core of the aggregation, the other was put into the box, the sender was lit, and the connection between the type interface was disconnected.The second material is sent to a block interface, if so,

2. The materials put in the box are evenly divided into the base

3. The material is sufficient, and the core of the aggregation continues to receive the redstone signal so that the synthesis begins

4. Synthesis is completed, the finished product is drawn away

• 

  National Service DNF Dark Ni

• 

  The new screenshot of the be

• 

  The 15th anniversary wallpap

• 

  3DM Xuanyuan Sinicization Gr

• 

  French magazine is the first

• 

  The sneak game "Republic" wi