your current location：首页 > news>Tips for the Dark (5) Safety Refining Method [GT6] Gregtech 6 (Gregtech 6) Minecraft Game

Tips for the Dark (5) Safety Refining Method [GT6] Gregtech 6 (Gregtech 6) Minecraft Game

2024-12-09 18:29:09|Myriagame |source：minecraft skins

Objective: 7 做 boards, do 目目

Materials and utensils: 铱, 15 buffers, liquid furnaces, chromium, chromium mold-board, monkey wrench, temperature sensor, pliers, sufficient liquid fuel fuel fuel

Introduction: There is a thrilling jump in the 技 Technology Line, that is, from chromium to 铱

The explosion temperature of the melting temperature from chromium is only 6K

If you want to refine it, people who have poor speed are afraid of going to the street

1. Two configurations used for example

1. The foundation

2. Advanced

Do not talk about the specific questions of the configuration, and then talk about

2. Raw material throwing and template settings

The buffer here is still 铱, and everyone can also use a liquid furnace with lower energy levels and carbon powder.

Invest all the one -time nature of 24 units, see the skills of the principle (1)

(24 pink or 20 pure ore, the latter is combined with 25 units, the ore ore can be washed from the platinum ore)

The reason for investing in 24 units is that we have to make 7 pupa boards with a capacity of 16, and add an 铱 to the temperature control, combine 24

In the picture, I use the board to replace

Use the monkey wrench to right -click along the inside of the mold on the side of the mold

Automatic output prompts appear

After that, the two configurations mentioned in the previous step are different. Of course, the difference is nothing more than the heating of the burning room to the 坩埚

The dense steel liquid furnace is definitely faster than the steel liquid furnace

Although we have set up automatic output, the heating speed of dense steel is still too fast

Not enough to let 次 have time to automatically output every time

Frequent explosions occur

Therefore, we need the instantaneous instantaneous block of the cricket in the pot into a pink.

Later, an 一 automatically exports a pupa board, and then automatically invested in a unit of a unit to reduce the temperature in the pot

Of course, we can also use redstone and pistons to operate

Use the monkey wrench to adjust the mold in the center of the mold and set it as a redstone signal to automatically output

Note that redstone

Just push the tie rod after seeing the pink into pink

Then, take out the pliers to quickly remove the board, and then put the mold back as soon as possible to reduce the calorie loss of the cricket

Then, if you ignite the stove, you can repeat the above operation seven times to get 7 boards

As for the remaining crickets in the 余, you can wait for the temperature to be reduced, just take it out with your hands

Then you can smell in the newly -made 冶

----------------------------------------------------------------------------------------------------------------------------

Below, the condition of the steel furnace with a steel liquid becomes slower because the heating speed becomes slower, and there is enough time to let the metal be automatically exported.

It can be said to be very safe

Just export and then remove it with pliers

However, its heating efficiency is too slow. Each refresh is only about 2K, and dense steel can reach 6K

If you want to heat up the 16 units in the 存 to 2719k, the steel is about 3 days, and the dense steel can be used for a day.

Of course, the hand speed is too slow and can only use ordinary steel furnaces

You can try it in the creation, be proficient in use before use, and recommend physical backup at the same time

more news

MORE +