your current location:首页 > news>Minecraft teaches you how to make a good -looking laser door

Minecraft teaches you how to make a good -looking laser door

2024-12-17 06:04:37|Myriagame |source:minecraft skins

The door in "Minecraft" is a very common item, and it is also very simple to make it.Six wooden boards are easily done, but such doors are not cool at all, so let Minecraft Chinese station teach you how to make a cool laser!Just like the picture below.

minecraft

first step

minecraft

Put on the ground (golden blocks, iron blocks, diamonds, and lower bounds alloy blocks) on the ground. Diamonds are diamonds here, and the beacon is placed on the diamond.In fact, it doesn't matter if the glass is not put, but it can make the laser door look better.

Step 2

minecraft

The next step is to put a viscous piston, and a block should be placed in front of the viscous piston.The position of viscous piston and block refers to the figure above.Because the laser of the beacon is more blocked, Xiaobian temporarily kill the block that activates it, but you don't need it when you make it.

Step 3

minecraft

Then set up a square block behind the viscous piston.Just like the picture above.This is to put the redstone circuit behind the viscous piston.

minecraft

Put the square on the blocks promoted by the viscous piston and adhesive piston, like the figure above.It is also to put the redstone circuit.

minecraft

Put the fence door on the two layers above the glass, these fence doors are the key device of this laser door.

Step 4

minecraft

Put the redstone relay behind this sticky piston and the fence door, and then connect the redstone relayr.Like the picture above.

minecraft

Put the squares on both sides, spread the redstone circuit, and put the button.Although it looks difficult, it can be made.

Step 5

minecraft

Put other places on the square, and the middle fence door, red stone relay, and redstone need not be placed.Like the picture above.

minecraft

Then attach the carpet, block the place just exposed, put the glass on it, and then block the other exposed places with a square.Then this laser door was achieved.If you find that the button is pressed, the laser disappears, but it is not possible.Then it may be that when you put a square block, you accidentally blocked the redstone circuit, which caused the door to open.

Principle: When the fence door is not opened, its height is a half height, and then placed the square on the height of the two layers above the fence door, and the person can't get it.