What is the use of a stumbling hook for the minecraft stumbling hook?

Class type: non -solid block

Passing: Yes

Renewal: Yes

Can stack: Yes (64)

Tripwire hook is a switch block that can be used in line.The stumbling hook is the fifth switch that adds Minecraft.

Synthetic table

Raw material

wooden stick

wooden board

Ingot

Different from the redstone line is that the thread can be placed in the air.The line itself has two states: ground or floating, and there is no need to put other blocks on the bottom in order to make it float.The necessary prerequisite for the successful laying of the stumbling line is that the overall overall of the stumbling hook -line long chain -stumbling hook must be located on the transparent square or below at the same time.

Once the line is laid, the stumbling hook will be pulled down a little, indicating that it is successfully laying.At this time, once any entity (including players, biology, arrows, mining vehicles, ships, but excluding the eye and enchantment bottle), the laid lines are paved, or the left mouse button or newly added new mouse button or newly added/Remove the blocks under any part of the stumbling system to destroy the laid lines (unless there is scissors in the hand), and the stumbling hooks on both sides will output red stone electricity.Walking around or removing the stumbling line (whether the scissors are used) are updated in the block, which can update the sensor induction for the square.

When the stumbling hook is activated, the stumbling hook itself is strongly charged with the blocks attached to it.After being destroyed online or the player/creature leaves the connection for 1 second, the stumbling hook will bounce up and stop the output power.

If the stumbling line is laid above the rail, it can be used to detect whether the mining car is an empty car.The detection of rails cannot detect whether the mining car is an empty car.

trap box