your current location:首页 > news>Use track with a target block to generate aura natural aura (Nature's Aura) Minecraft Game

Use track with a target block to generate aura natural aura (Nature's Aura) Minecraft Game

2024-12-10 17:44:45|Myriagame |source:minecraft skins

This tutorial is set by the author to use the CC By-NC-SA protocol.

Earlier articles have been existing: simplicity to generate aura through shooting target blocks and control the amount of aura.

This tutorial shows the exquisite scheme that only uses the original redstone.

The characteristics of the basic device

Use only the original redstone, which is high in general

The device volume is only 5 × 5 × 2

However, to complete the volume of automatic control, you need to use a little more space.

Basic device

We only need to put on the funnel mining car or store the box and mining car, and make it drive clockwise, and the device can start operation.

(Device display: Basic version)

Note: Because the update order of the shooting target is clockwise, the moving line of the mining car must also be clockwise.

principle:

The mining car drove across the pressure rails to activate the launcher, but also accelerated the energy to accelerate the rails.

The mining car has accelerated the rails to improve the kinetic energy.

The miner drove through the funnel and injected the snowball into the transmitter.

Activate the launcher again and follow this.

Snowball automation

We can use the gangster generator of the same module with the snowman to achieve the automation of snowballs.

(Device display: with the snowball factory)

Note: The squares under the feet of the snowman must be full brick or upper half brick.

Instead of the storage box and mining car with a funnel mining car, it can not only provide snowballs for the launcher, but also automatically collect it. One stone and two birds ~

Switch control

We can also add a small design to facilitate our switching device.

(Device display: with switch)

We only need to pull down the lever to stop the device.After stopping the device, you only need to reset the pull rod to drive automatically ~

In the same way, replacing the tie rod to the aura detector can control the amount of aura.

(Device display: with Reiki detector)

Complete solution

Integrate the solution of the above content production.

(Complete device: Automatic aura volume control)