your current location：首页 > news>AE -automatic synthetic device combination method description [AE] Application energy (Applied Energistics 1) Minecraft

AE -automatic synthetic device combination method description [AE] Application energy (Applied Energistics 1) Minecraft

2024-12-10 17:45:30|Myriagame |source：minecraft skins

The AE automatic synthetic device needs to be connected to the storage network to work. The three types of blocks: mold supply, synthetic CPU, heat dissipation hole, and assembly wall can only be worked in accordance with the prescribed swing method.

The mold supplier mainly provides the placement space of the template (formula). The synthetic CPU is to speed up the synthetic speed. The other two are filled with the frame and surface. There are demonstrations below.

First display the construction method of the synthetic device of 3*3

The bottom layer is placed in the method as shown in the figure and the wall seal the wall

The second layer is four corners

The upper layer is the same way as the bottom layer

At this time, the framework of 3*3*3 is set up. The surface should be able to fill in six blocks, and one block is empty in the middle part.

In order to see clearly, I removed the three editing walls on the side.As shown in the figure, all the places on the surface are filled with the heat dissipation holes, and there are two on the picture.

This is like this after filling, but it has not been completed, and there are vacancies in the middle part, so the rest of the place must be filled with synthetic CPU and mold supply.

3*3*3 Structure can only be placed in one square internally, so this structure is the only way to build a component. This structure can be placed in a mold supply in the middle (saving a synthetic CPU), Then you can complete the construction method of specially recommended in the early stage.

Fill in a mold supply in the middle

After the surface is sealed, the overall appearance will change. At this time, the easiest AE automatic synthetic device will be completed. At this time, you must open the synthetic device to add the synthetic template directly to any square.If the unsuccessful changes are changed, please check it carefully, right?

Below I will build a 4*4*4 synthetic device as a demonstration

Same as the previous 3*3*3, build a framework with a compilation wall

Fill it with a heat dissipation hole when the surface is empty (four are used in each side)

At this time, there are eight blocks in the middle, so you must fill in the synthetic CPU and mold supply to meet the standards.

Then seal the surface with a heat dissipation hole

The appearance will change after completion.

The framework can continue to expand. The construction method is the same, so I won't go into details.

Finally, I hope everyone will like AEMOD, the introduction is here

more news

MORE +