your current location:首页 > news>[Keen Energy Engineering 3] Equity Tutorial (3): How to use channels [TEN3] Technical Engineering 3 (Technical Engineeri

[Keen Energy Engineering 3] Equity Tutorial (3): How to use channels [TEN3] Technical Engineering 3 (Technical Engineeri

2024-12-10 17:45:35|Myriagame |source:minecraft skins

How to use channels

The figure is the installation of the channel.The channel can be installed in the six directions of the square and independent of each other.

Before using the channel, you need to make a channel bridge.There are three modes of the bridge (press the C key to switch mode):

Add push channel: In the first selected channel, add the second selected channel as an output source.

Add drawing channel: In the first selected channel, add the second selected channel as a source of input.

Remove Channel: Remove the second selected channel in the first selected channel.

Each game of the channel will automatically extract all the [energy/items/fluids] of all drawing channels, and automatically push your [energy/item/fluid] to all push channels.

When the target channel does not exist (maybe it has been destroyed), this channel will be automatically removed from the list.

When using a bridge connection binding process, the previously selected channel does not exist, and a prompt will be issued.At this time, the C key can be removed to remove the cache in order to re -select.

Now we have added success.GUI will display the binding channels.

The channel can also automatically interact with its attached blocks.Just turn on the active mode.

The so -called "front side" is actually the attachment of the channel.

The picture shows the item channel.The fluid channel is also the same.

Of course, the channel and the cable or pipeline are also available.