your current location:首页 > news>The characteristics of pollutants and pollution in the field of environmental pollution/field (Pollution of the Realms)

The characteristics of pollutants and pollution in the field of environmental pollution/field (Pollution of the Realms)

2024-12-10 17:45:53|Myriagame |source:minecraft skins

The pollution discharge generated in the module does not add a height of the height of about Y = 128, and it will spread over time.

In addition to affecting air quality, these emissions are mainly the impact on ecology.

The plants below the carbon emissions will accelerate the growth, soil will be transformed into grass squares, and weeds will grow.

Sulfur emissions are opposite, which will wither the plants below. Crops and sugar cane will disappear directly.

The third emission-dust will float down when it is generated.Finally pile up on the rock or be absorbed by the grass.

The grass that absorbs dust will become a straw diameter.

Because carbon emissions can promote the growth of plants, an appropriate amount of carbon emissions may not be a bad thing.However, a large amount of carbon emissions gathering will not only increase the gas pollution, but also cover the sun, and then form a monster area below.

Sulfur discharge can be used to transform the gray -based soil, although this is not a good choice.Because a large range of plants under sulfur discharge will die due to pollution.The control of sulfur discharge is limited to a certain range and easily causes explosion.

At the same time, although nature has a certain self -healing ability, sulfur emissions are more difficult to disappear naturally than carbon emissions.

However, the module provides filter blocks for preventing sulfur pollution.

When the sulfur discharge is passed through the filter, it is absorbed by the filter, but carbon emissions and dust will not be absorbed.

All three discharge can be passed through the leaves.And the leaves have a high chance to absorb carbon emissions.(The 5x5 area in the figure below is placed with a 3 -level concentration of carbon rowing objects, but in the end only two have passed through the leaves)

Dust can also be absorbed with leaves, but the leaves that absorb dust will die immediately.(The figure below shows the degree of dust absorption of the three concentrations of the leaves)

The leaves are very effective in the early or late period as cheap cleaning blocks, but it should be noted that sulfur emissions will kill all the leaves through the leaves without being absorbed.

Therefore, minimize the emissions of sulfur in the early stages of survival until it has effective governance methods.After the filter is made in the later period, you can use the leaves to directly solve the pollution problem directly on the source.