your current location：首页 > news>A 3X4X5 (7) Label Caller Motor Operation Plan [CR] Crossroids Minecraft Game

A 3X4X5 (7) Label Caller Motor Operation Plan [CR] Crossroids Minecraft Game

2024-12-10 17:46:20|Myriagame |source：minecraft skins

This tutorial is set by the author to use the CC by-NC protocol.

Although the complicated maintenance conditions of the beacon of the benchmark for the vertical vendor allows players to build a huge and complex machine to maintain it, we can still simplify it. The following is a 3x4x5 beacon operator running scheme.

Materials required: 1x beacon; 9X metal block; 6X arbitrary block; 1x beacon manipulator; 1x crystalline prism; 6x beam siphon; 3X quartz stabilizer; 9X circuit wiring board; 4x redstone signal transmitter; 5X red redStone signal receiver; total 45 blocks.

First set the operating environment of the benchmark operator.

Place the crystal prism every one.

Put the arrow on the three sides of the lens red and green, the nie -beam siphon, and the quartz stabilizer (power is 1) on the front of the siphon.

Place the beam siphon in the directly above the three quartz stabilizers, and the arrows are facing the beacon operator.

At this point, the main part is equipped, and the circuit part is next.

Expand the label platform along the direction of green light.

Put down the circuit as shown in the figure. Among them, the three blocks of traffic and blue are the redstone signal transmitter after the dyed. The clock circuit parameters are (240, 80).80.

Place the black surface of the crystallization prism, as shown in the three redstone signal receivers.

Place red stones on both sides of the red brick beam siphon.

The extension platform is placed as shown in the figure. The green is the redstone signal receiver, and the yellow is a redstone signal transmitter. The delayed circuit parameter is 60.

Add a green redstone signal receiver.

Finally, link all the transmitters and receivers of the same color (the green should be two) with a link tool.

Before you even, please link the time entropy slot for the beacon manipulator, unless you want to see a bombed machine.

The circuit part is completed here, and the startup part is next.

Inject Blu -ray (recommended alchemy salt) to the quartz stabilizer in the pointer position, and remove it after stability.

A beam permanent motivation was built.

Some supplements:

Before the linked redstone, be sure to make sure that the beacon operator links the time entropy slot!

If you want to store the beam, you can install quartz stabilizers at the bottom (16 power can be output stably, and 32 power will have a short period of time).

The beam permanent motivation can be installed separately.

You can use the surface to block the beam output on the side.

Dyeing is not necessary, but it is very useful.

A 8 -storage bit single -chip basic light beam editor (can be used as an additional installation)

more news

MORE +