2024-12-10 17:47:18|Myriagame |source:minecraft skins
This tutorial is set by the author's setting without permission.
Encared to the inefficient steam efficiency of a single boiler?Try multi -block boiler.
The difference between multi -square block and unilateral boiler is:
The unilateral steam groove will not consume fuels after full. How much EU energy is generated by the amount of EU energy in the fuel (a small part of the energy will be wasted during the heating stage).
After the multi -square steam trough is full, it will still consume fuel, which will bring extremely high efficiency. After reaching the maximum temperature, the efficiency of fuel utilization can be increased to 200%.
Prelimation of the low pressure phase:
Low pressure late
The use of large steam boiler and advanced version
Input water, fuel (solid and liquid), output steam, simple and easy to use.
Large steam boilers are the same as the advanced version. There are only large steam boilers as an example. The advanced version uses the same ordinary version.
High -voltage phase
Once it is high pressure, it is not as convenient and fast as low pressure. As you can only use high -pressure liquids to evaporate, it is troublesome.
Here is an additional to the supercharger and the heat switch
Large steam boiler and advanced version boiler
Previous: ordinary version; post -: advanced version
Booster
Here is a booster to press the water to put water to high pressure water for boiler.
Hot switch
Unlike other machines, the heat switch used for liquid/steam heat exchange is used up and down stacked to share the square
Reasons for heat exchange
The consumption of 76800EU can only produce 125MB of high pressure water. After 1: 16 = liquid: The ratio of the steam is converted to 2000MB high -pressure steam, and after entering the steam turbine, it can only produce 16000EU, and the steam turbine does not return to the liquid.The less comparable to the potatoes next door.
Therefore, it is necessary to change high -pressure steam and water heat to get high -pressure water and ordinary steam.
The use of large steam boiler and advanced version
process
Give an example
Two boilers are similar, with an advanced version as an example here
Device
Use 4 sets of high -voltage boilers, 2 sets of heat exchange (energy input is upgraded to high -voltage input here), a set of turbine power generation (a small number of heat switches).
Unlimited items: Infinite fuel (here are coke powder), infinite water.
limited:
High -pressure water of the two titanium storage tanks.
Use quantum cylinder to install ordinary steam.
In actual use, it can be stored and automated with MODs such as AE2.
Pipe
boiler
: Item pipeline (not turned on here, the model has not been changed)
The blue fluid pipes input high -pressure water, and the light -gray fluid pipes output high -pressure steam.
Hot switch
Note: The input and output warehouse needs to lock the fluid.
turbine
More than 32 grid flow pipes are used to transmit steam
Intermediate fluid input, the turbine output by ultra -high -pressure energy, uses an ultra -high -voltage storage unit to store power, and lower blood pressure to be used for high -voltage heating exchange.
Driving process
Enter the steam for the turbine or charge the storage unit to ensure that the thermal switch is electric.
Make sure the overclocking of the thermal switch can reach the maximum (600eu/t).
Enter high -pressure water for the boiler
Enter water for the hot switch
Enter fuel for boiler
Use lubricating oil to achieve the highest work efficiency
Check high -voltage water level
At this time, the device entered a stable operation and produced 32B/T steam.
The system has a waste of fuel. A hot exchange can only be replaced with 16000EU steam, and the output of the two boilers is greater than 16000eu. Therefore, a set of heat exchanges barely drive two sets of advanced high -pressure boilers.
In fact, less than 4 sets of advanced high -voltage boilers are used to make two sets of excessive enough to the next stage.
Ultra -high pressure
nuclear reactor
There are many nuclear reactors, and the medium size is selected here, and a set of layout I like to use.
Item/fluid location
Pipe
Red fluid: output 蓝; blue fluid: input water; white fluid: output steam (placed more to enhance transmission)
Green item: input nuclear fuel rod/output dry fuel stick
Demonstration of infinite water, infinite fuel rods, quantum cylinder storage steam and 氘
In actual use, steam can be stored with other MODs.
Effect
30%efficiency, 4WMB/T steam output, 9.5MB/T 氘 output
Simple and rude and easy to use.
However, when using other non -water liquids for nuclear reactions, it still needs to be used with hot switch.
Steam end
At this point, all medium and late stages of steam source introduction
National Service DNF Dark Ni
2025-01-28 09:19:27The new screenshot of the be
2025-01-28 09:18:57The 15th anniversary wallpap
2025-01-28 09:18:273DM Xuanyuan Sinicization Gr
2025-01-28 09:17:57French magazine is the first
2025-01-28 09:17:27The sneak game "Republic" wi
2025-01-28 09:16:57The story between humans and
2025-01-28 09:16:27Capture "Trinity 3: Artifact
2025-01-28 09:15:27Wind direction change "Myste
2025-01-28 09:14:57DICE's new project "Dream" w
2025-01-28 09:14:27Pirate Minecraft Skins
Minecraft Skins
2024-12-10 04:11:27Pirate Minecraft Skins
Minecraft Skins
2024-12-10 04:11:26Master Minecraft Skins
Minecraft Skins
2024-12-10 04:11:25King Minecraft Skins
Minecraft Skins
2024-12-10 04:11:25Guide Minecraft Skins
Minecraft Skins
2024-12-10 04:11:24Dark Knight Minecraft Skins
Minecraft Skins
2024-12-10 04:11:23Sparta Minecraft Skins
Minecraft Skins
2024-12-10 04:11:23Moncraft Skins of the War
Minecraft Skins
2024-12-10 04:11:22Red Witch Minecraft Skins
Minecraft Skins
2024-12-10 04:11:22Golden Cavaliers Minecraft S
Minecraft Skins
2024-12-10 04:11:22