your current location:首页 > news>Automatic 6 -faced crystal spawning device [DJ2] Divine Journey 2) Minecraft Game

Automatic 6 -faced crystal spawning device [DJ2] Divine Journey 2) Minecraft Game

2024-12-10 17:47:19|Myriagame |source:minecraft skins

This tutorial is set by the author's setting without permission.

As shown in the redstone part of the device, the explanation:

The main body of the device is divided into two parts, one is the part used to lose items and finish (picture left), the input is the signal of the stumbling hook, and the output is the red stone in the middle.

In order to facilitate understanding, the first part of the first part of the first part of the explanation below is to make the first part of the output refers to this grid.

One is a device used to start viscous piston and timely reset (picture right)

The input is the red stone in the middle, and the output is the wooden board facing the RS memory.

Explanation of the work machine:

First, in the first part, there is a 1Tick signal output after being lost through the 1TICK delay+non -door:

Under normal conditions, output redstone signals;

When starting to lose items, the upper stumbling hook is activated to enter the redstone signal,

After 3tick, the output high -red stone position is taken over by the relayr above, and

After 1Tick, the non -door activation, stop output below;

When the items are lost, the input signal goes off,

After 3tick, the upper relay extinguishes, and the output red stone becomes a low signal

After 1Tick, the non -door reset, the output signal is reset to a high signal.

2. In the second part, realize the first part of the 1Tick signal output into a continuous signal and automatically reset

First of all, using non -goalkeeper to turn the conventional activation status into a high redstone signal of 1Tick after losing the item;

Use the RS memory to lock the 1Tick signal and output to the wooden board;

When not activated, the RS memory locks the timer is not activated; after the activation, the RS memory releases the timer, and the timer will emit redstone signal reset the RS lock in one week.

Finally, don't forget to place a ME trigger bus for the inlet of the six crystal birthpots (receiving the redstone signal channel, otherwise disconnected),

Access the redstone signal output from the board to achieve automatic power off (these six crystal birthprors are quite electricity)

At this point, the construction of the entire device has been completed.

Compared with the traditional 5 -sided ring water device, the following advantages have the following advantages:

The speed is improved to the highest theory.

Don't be afraid to close it if you can't lose the sixth side (even if the hand speed is slower: you can step on the stumbling hook and throw it, and start the device when it is lost).

Precise timing, no waste of electricity.