Let the benchmark operator continue to run [Cr] Minecraft Game

2024-12-10 17:47:33|Myriagame |source：minecraft skins

After you unlock all the beams and choose the way of technology magic, you have to consume a lot of materials to maintain the beam to produce 0 cost output through the beacon operator.

However, its maintenance conditions are very harsh, and it needs to be irradiated with three kinds of pure light column with red, green, and blue in order.

Fortunately, the Essentials module provides us with extremely convenient red stone elements, so that the maintenance of the beacon operator is no longer difficult.

First of all, you need to put the operating environment of the benchmark operator.

Then connect it to the entropy groove and entropy node.

Put the crystal prism at the position directly below the beacon operator.

Put the beam reflex on the three sides of the lens red and green, and put down the quartz stabilizer facing the beacon operator directly above the reflector.

As shown in the figure, put down the redstone signal receiver, circuit board (circuit interface board mode), and redstone.

Place the redstone elements as shown below at any quartz stabilizer, and the remaining two are also processed.(Pistons must use viscous piston)

Take the new place and build the platform shown in the figure below.(4 here are redstone signal transmitters, the circuit board adopts a delay circuit mode)

Enter 80 and 160 into two circuit boards.

Use the link tool to link the redstone signal transmitter and the receiver:

The transmitter without a delay circuit links the red light beam and the green beam receiver (only one receiver is connected to each channel)

Just like this: (here to remove the entropy groove in order not to affect the perception, there is no need to remove it in actual operation)

In the same way, the receiver next to the two beams of green and blue beams delayed 80.

The delayed 160 receiver next to the blue and red beams.

The redstone signal transmitter at the rear links to the receiver of the benchmark operator.

Change the circuit board at the end of the circuit to the clock circuit and enter 240 and 80.And change its second circuit board to a delay circuit with a parameter of 20.

The last step is to inject Blu -ray into the launching funds to the quartz stabilizer of the blue light beam.

Then you will find that you have successfully manufactured a permanent motivation. The light beams produced are far more output than quartz stabilizers (unless you adjust the output value of the stabilizer too much), so you can rest assured that you can rest assuredUse these beams to do what you want to do.But because the internal cache of the stabilizer is only 1024 beams, do not let them leave the beam for too long.

• 

  National Service DNF Dark Ni

• 

  The new screenshot of the be

• 

  The 15th anniversary wallpap

• 

  3DM Xuanyuan Sinicization Gr

• 

  French magazine is the first

• 

  The sneak game "Republic" wi