MSD's simplest use tutorial [MSD] MTR station decoration

2024-12-10 17:48:47|Myriagame |source：minecraft skins

For the contact network, all blocks (including node blocks) do not have special attributes. They are just ordinary MC blocks, so you can use Worldedit with confidence.

The idea of ​​the contact network is the railway connection from the MTR. Use the connector to click two nodes to make them connect.

The main reason is that in order to provide a variety of possibilities (and the restrictions of the original MC original block model, one is lazy), the entire shelf is dismantled into several parts, and the use is just like a building.

For example, to build the simplest contact network shelf (2 squares and half), use [pillars], [contact mesh (pillars)], [contact grid (component 2)], [contact grid (component 1)], [Contact web node (style 1/2)], the order order is shown in the figure, as shown in the figure, as shown in the figure,

Among them, the red part is [pillar], yellow is [contact grid (pillar)], blue is [contact grid (component 2)], purple is [contact grid (component 1)], green is [contact network node node(Style 1/2)].

The short contact grid and long contact grid are similar. Just replace the blocks except the pillars to a short contact mesh block with the corresponding name, but there is only one part [contact mesh (component)]Grid), the effect is as shown in the figure:

Replace the [contact grid (pillars)] with [contact grid (pillar & on both sides)], which can allow both sides of the telephone pole to have contact mesh, just place the square in the order of the above.The effect is shown in the figure:

There is also a scenario that is used to hang under the dragon gate, which is generally used for multiple tracks. You only need to replace [contact mesh (pillars)] or [contact grid (pillars & on both sides)] withCorresponding to the length of [contact grid (top)].

The picture below is the effect of the effect (note that the [contact grid (top)] model of the dragon gate is two highs, but only one block is occupied, so two squares must be placed in a row and then knocked out the one above).

In addition, there are decorative wires. Like the contact network, the wires are also used to use the connector to connect to two nodes. The wire node can find a hanging place.It is also very simple to use, [electric pole (top)] or [electric pole (top & on both sides)] only needs to be placed on the top of [pillars], and then click [electric wire node] to stretch outThe one or two small horizontal rods are OK (the nature of the wire node is the same as that of the end candle, and the bottom model at the bottom of the square will be facing down). The effect is as shown in the figure:

Of course, these two rods can also be placed on the side of the pole. Just use [electric pole (side)] to click the side of [column] (of course, not necessarily the pillar, [contact the grid (pillar)] or or[Short contact grid (pillars)] on the side can also be), and there is a [electric pole (other side)], which can be placed on the other side. The effect is shown in the figure:

Of course, it is best to cooperate with contact with the network shelf

The essence is to accumulate wood, so just follow your own thoughts.

• 

  National Service DNF Dark Ni

• 

  The new screenshot of the be

• 

  The 15th anniversary wallpap

• 

  3DM Xuanyuan Sinicization Gr

• 

  French magazine is the first

• 

  The sneak game "Republic" wi