[Hard Euctor] The WATZ power plant of HBM's nuclear technology with the Pump of Industry 2 uses the semi -automated

2024-12-10 17:52:32|Myriagame |source：minecraft skins

Note: This method is wrong. If there is a better solution, welcome to discuss

As we all know, for various reasons, HBM's WATZ is difficult to achieve automated management. If you are not careful, you may cause losses and produce a large amount of poisonous mud. Here is a hard core but relatively practical method to achieve semi -automated poisoned mud treatment treatment.

Since the HBM fluid system is different from the modules such as BC, it is not feasible to use BC to treat the poisoned mud, but the poisonous mud can be absorbed by the pump of IC2 and supports the barrel to contain the tolerance.

At the same time, the pump of IC2 is very fast, and the poisonous mud can be absorbed in a short time, so don’t worry about blocking

Next is the general idea:

1. Leave a grid in front of the Watz access interface, and use a block that will not be corroded by poisoned mud, and use the pump to quasirate the Watz access interface (the four interfaces before the operation need to be done)

2. The pump is connected to the power supply and connect to the box with a funnel (one of them is used to input buckets and output mud barrels, and the output end can be connected to the CMB steelmaking furnace)

3. Put the titanium filter and start running. Waiting for the overflowing of the mud. I want to keep the materials that can be preserved. The pumps of the remaining interfaces are removed because the watz is overflowing a mouth by default.

• 

  National Service DNF Dark Ni

• 

  The new screenshot of the be

• 

  The 15th anniversary wallpap

• 

  3DM Xuanyuan Sinicization Gr

• 

  French magazine is the first

• 

  The sneak game "Republic" wi