your current location:首页 > news>Application and precautions for vector transformation interfaces

Application and precautions for vector transformation interfaces

2024-12-10 17:52:35|Myriagame |source:minecraft skins

1. Introduction

In the research of mysterious craftsmen, there is a vector transformation interface, as shown in the figure below

According to the manual, it can input and output a lot of things, such as:

RF pipeline → interface → BC machine

IC wire → interface → IC machine

Fluid pipe → interface → fluid pipeline

The maximum interval is three grids.

Use a vector transformation binder to bind the interface with the square

2. How to use examples

① The presentation of the figure below is to use the vector transformation interface to power the induction furnace through the MFSU across the air. Through the right side of the interface (right side), it is prompted to set the position, and then press the Shift right -click the sensor of the induction furnace (direct directly (directRight -click will be opened), prompting the binding, this is a successful binding. Sometimes the situation is not provided after binding. You can bind it again or remove the input wire and remove it again.

BC's energy can also be passed in a similar way.

② The following demonstration is to use the interface to transmit liquid

Similar to the method of the previous example, connect the pipeline, and then bind the interface to the side of the storage tank

Using this interface, we can achieve a lot of useful functions, such as transmitting the power station of the nuclear power plant through explosion -proof glass, and hemi no longer has to worry about the nuclear power explosion!

3. Precautions

① The maximum distance of the vector transformation interface is 3 squares, so do not let the binding blocks too far away from it (the two examples above are the largest distance). The distance here refers toThe number of blocks in the middle has nothing to do with which side of the block you bind.

② After using the binder to bind a certain surface of the interface to a block, this surface is considered as the output port, and other unbounded surfaces can be regarded as input.

③Warning!IntersectionIntersectionIntersectionIntersectionIntersectionIntersectionIntersectionIntersectionIntersectionNever bind the interface to the IC wire!IntersectionFor example, the figure below is a very dead behavior

I chose one side of the interface, and then I wanted to bind it to the diamond cable pointed to the pointer. When I right -click, my game will instantly collapse, and then the archive cannot enter.The map editor reset this block can be repaired and archived, but it will cause this block to no longer place the IC wire. Once placed, it will collapse, so when using this thing, you must pay attention to this.Don't say anything.