your current location：首页 > news>Pure Industry 2 Destroy Heat Water [IC2] Industrial Age 2 (INDUSTRIAL CRAFT 2) Minecraft Game

Pure Industry 2 Destroy Heat Water [IC2] Industrial Age 2 (INDUSTRIAL CRAFT 2) Minecraft Game

2024-12-10 17:53:02|Myriagame |source：minecraft skins

Only the abandoned hot water produced by the Energy generator of Stirling in the case of industrial 2MOD

Principles of the original transmitter destroy the fluid:

The transmitter is activated once when receiving the redstone signal, and the storage items are emitted.

If it is equipped with a 1000MB fluid container, the corresponding fluid block will be placed in front of the port of the transmitter to leave an empty fluid container.

The figure below.There is a universal fluid unit containing 1000MB of water with a transmitter

Pure Industry 2 Stelin Power Nuclear Power-14th Picture

The figure below.Give the transmitter a redstone signal, and place a corresponding fluid block in front of the transmitter

Pure Industry 2 Stelin Power Nuclear Power-15th Picture

The figure below.The transmitter emits the fluid and leaves a vacuum unit (the general fluid unit with a universal fluid with 1000MB of fluid can be transmitted. Other MBs such as 999MB will be emitted as an item! Of course, if other MOD changes the original mechanism or the MOD versionThere may be differences)

Pure Industry 2 Stelin Power Nuclear Power-16th Picture

This mechanism is suitable for all fluids except for being unable to place!

Stelin's energy generator mechanism

A: The input port must be a fluid container equipped with water, otherwise it will not enter!

B: Output terminal, output empty fluid container.

C: The input port must be an empty fluid container, or a container with no hot water, otherwise it will not enter!

D: Output end, output fluid container filled with hot water.

From the above, we can see that the Sterling Power Generator adds to the upgrade and upgrade can be automatically drawn into the required items.

Note:

The conversion ratio of Sterling Power generator is:

Each: 4HU thermal energy add 1Mb water to get 1MB of hot water

A 100HU/T fluid heat switch can make Sterling Powers produced 500MB of hot water, so the transmitter can be adjusted to one pulse once in 2 seconds.

Two fluid heat exchangers are once a second pulse, three units of 0.67 seconds, four units of 0.5 seconds, and 5.24 seconds (it is recommended to leave a little redundant, otherwise it is easy to explode)

The following is the overall design

First of all, the problem of stuck: A single red stone powder pulse card with a single red stone powder of 1 second after power -on, and 6 times the redstone powder than the rails such as charging energy rails

So electricity transmission suggests insulating wire or glass fiber wire

Redstone pulse transmission is recommended to charge the rail (other rails are also good, but it can be activated by the redstone signal)

Run the sequence below.

Two streaming heat switches transmit calories to Stelin's energy generator with 100HU/T, and the water pump pops up the water four weeks.

Stelin's energy generator generates dynamic energy and generates 50Mb/T hot water.When the C -slot's fluid container is filled with hot water, the output is output to the D slot, and the upgrade is popped into the adjacent transmitter.

The transmitter was activated by the 1S erythema pulse, the fluid in the launch container, and the empty fluid container was pulled back to the Sterling Power generator to complete a reincarnation.(The front of the launcher must be an air square)

Redstone pulse everyone designs (or leave a message to me, I think the situation is designed for you)

Pay attention to try not to use red stone powder and red stone torch.

------end------

more news

MORE +