your current location：首页 > news>Simple overloaded road device [IE] immersive engineering

Simple overloaded road device [IE] immersive engineering

2024-12-10 17:54:16|Myriagame |source：minecraft skins

This tutorial is set by the author's setting without permission.

Note: Can't guarantee 100%

As we all know, in IE, when the cable exceeds the maximum input rate, it will be burned. Although it is just a small trouble, it is easy to solve it

After the generator burned how many lines, I don’t know how many lines, I developed this simple overloaded circuit breaker. The structure is as shown in the figure.

(The battery packs on both sides are generators and electrical appliances, and the pits are comparatives)

Core principle: When the current transformer is about 32000IF/T. When the current is about to overload around 32000IF/T. The latter redstone comparator will output a signal of 15 intensity.However, the lower current also outputs the signal, so it is necessary to use the redstone line to circulate, attenuate signals, and finally connect to the redstone knife gate and the piston.Because the knife gate disappears after the cutting circuit is disconnected, the redstone signal disappears, and finally the power is turned on, it will still burn the wires, so add a piston and directly push off the electric wire to achieve the "broken path" in the physical sense.

Q & A

Q: How to recover after disconnection?

A: Just pull the line back, remember to see if the manual switch is turned on

Q: Why is it still burning?

A: You can't guarantee that you don't burn the line 100%. You can see which power gate can be 100%in reality.

more news

MORE +