your current location：首页 > news>Mechanical Power: Industry -Oil well Construction Tutorial [TFMG] Mechanical Power: Create: Industry/Create: The Factory

Mechanical Power: Industry -Oil well Construction Tutorial [TFMG] Mechanical Power: Create: Industry/Create: The Factory

2024-12-10 17:58:15|Myriagame |source：minecraft skins

This tutorial is set by the author's setting without permission.

Oil well component synthesis

In this module, oil wells and crude oil are the basis for supporting all power equipment in this module

See the oil well components below:

Oil-puma base-Pumpjack Base

Synthetic materials: thick steel plate*3, precision component*2, industrial pipe*1, steel ingot (the steel ingots of this module are consistent with the steel ingots of the alloy)*2

Industrial Tube -industrail Pipe

Synthetic material: Steel ingot -Cutting stone/square cutting

Steel truss

Synthetic material: Steel ingot -Cutting stone/square cutting

Oil-pumping machine hammer-Pumpjack Hammer Holder

Synthetic materials: Use automatic synthesis, see the figure above

Enter the machine -machine input

Synthetic materials: precision components*2, electronic tube*1, transmission rod*1, heavy mechanical shell-Heavy Machinery Casing

Heavy mechanical shell-Heavy Machinery Casing

Synthetic materials: Use robotic hand (thick steel plate) -The steel case -Steel Casing

(If you need to know the production of the steel case, please install the Jei item manager in the game to view it by yourself)

Crude Oil Scanner-Surface Scanner

Use: Power Synthetic-Materials See

Oil well construction

1. First of all, we need to find a base rock containing crude oil, and use crude oil scanners (access stress) to determine the location of crude oil (coordinates):

You need to bring the engineer's goggles: green is the place where the crude oil is located

2. After determining the position, keep dug down until you dig to the crude oil base rock mine. After that, the industrial pipes are built upwards, and the base of the oil pump is placed on the top:

3. Place two high steel truss behind it, and place the oil pumping machine hammer above it (note !!! Be sure to carry the red label on the base of the oil pump to the oil pump hammer !!! It is important!))

4. Place the output machine with the oil pumping machine with the oil pumping machine. You will find that the hammer frame is connected to the base. If not, then put the joystick in another direction!

5. Then give the output machine access stress. Pay attention to let it show level4 so that there can be the maximum power

6. Connect the steel pump and steel pipeline to the base, connect to the fluid storage tank, so that there will be a steady stream of crude oil ~

That's it for today's tutorial. Newcomers may have bad places, please point out!

Next issue: distillation tower

more news

MORE +