The use and management of batteries in ELN [ELN] Electrical Age Minecraft Game

2024-12-10 17:58:29|Myriagame |source：minecraft skins

The battery here is not a battery like the sink, it is close to the real battery with its characteristics.However, the capacity is hacked

The first point is that the batteries here have positive and negative.(Electric electrodes are isolated from ground) (important!)

Different batteries have different characteristics. Basic batteries can synthesize different characteristics batteries. They optimize different characteristics, such as longer life, higher voltageDischarge.

1: Charging and discharging curve and life:

Graphs from wiki.

Percentage refers to the percentage of battery energy storage.

Like reality, the battery here has a charging and discharge curve.There is a voltage platform in the section of 90-20 %, which is the discharge platform.In this paragraph, the battery voltage is relatively stable and the battery is very comfortable.This also causes you to use part of the nominal capacity and not all.For example, you can only let it through the energy of 40KJ batteries.

life.The battery here does not have a renewal method such as adding sulfate solution and pulse charging, so please treat your battery well.As the life of the battery decreases, the curve will become increasingly unstable, and the power storage capacity will decrease, and the internal resistance will rise until the life will reach 10 %.At that time, it would perform like a capacitor with great resistance.Please cherish lead resources.

A: Please do not fall the battery in the circuit and let it charging and discharge freely.Generally, the 50V power generation system will go to around 59V, so that your battery has been seriously charged.At the same time, opening a large amount of devices in a short time will allow the battery to discharge quickly, and it will even be seriously put in you unknowingly.This is a very bad thing for batteries.If you have conditions, you must do a battery management system. Let your battery be charged to 55V and then prevent over -charge. It is also offline to prevent override.In this way, your battery life will be several times more than you use it at will

B: Don't let it run it at the power that exceeds it to design the power charging power.It is a battery, not a capacitor.In the limit limit, the battery life will fall quickly, and the battery temperature will rise to the degree of danger, causing explosion.If the device is not afraid of the power loss, it is recommended to add the protection system. Of course, the most important thing is to consider these when the design system is designed and be careful.

2: Balance.If you do a battery array, you may consider the issue of balance.Although the battery here is not discrete, the wire resistance will also cause problems.At the beginning, after several cycles, the life of some batteries is slightly different from the voltage and other batteries, but never ignore it. Over time, these differences will become larger and larger until some batteries are almost hung.Some batteries are still seven -layer, and you will find that this battery array can hardly be filled.Use balance charging technology at all times!

• 

  National Service DNF Dark Ni

• 

  The new screenshot of the be

• 

  The 15th anniversary wallpap

• 

  3DM Xuanyuan Sinicization Gr

• 

  French magazine is the first

• 

  The sneak game "Republic" wi